QUICK 936A Soldering Station with Blue Stand

Half the burnt cables and scorched mats on a repair bench come from an iron laid down without a proper holder. The QUICK 936A soldering station comes with its own blue iron stand, so the hot handle always has a safe place between joints.

The listing describes adjustable, temperature-controlled heating for phone boards, PCB traces, ICs and SMD parts. It doesn't publish power, temperature range, voltage, plug or tip type, so check the photos or ask before ordering.

Bench jobs it covers

• A broken charge connector being resoldered.

• Jumper wire across a damaged trace.

• Loose SMD parts after a drop.

• Shorted capacitors lifted and replaced.

Setting it up

Place the stand on the side of your working hand so the iron goes back without reaching across the board. Start at a moderate temperature and raise it only if solder flows slowly, and add flux on old or oxidized joints.

A simple station like this suits general board work, training benches or a second position in the shop. Keep the tip tinned whenever the iron sits in the stand.